Cleaning Recommendations and Maintenance Instructions
The terminal may be cleaned with any proprietary computer screen cleaning material.
- Pre-impregnated micro-fiber cloths or tissues are preferable. If spray products are used, take care to avoid run-off and do not allow any liquid to enter the terminal case.
- For a smear-free finish, polish with a dry, clean, lint-free cloth.
- DO NOT use any other janitorial products, acids, solvents, polishes or abrasives
Cleaning Frequency: Terminal display and housing, card Slot, and finger scan window should be cleaned at regular intervals or as needed to insure proper operating conditions. Monthly cleaning is recommended for light use, weekly cleaning is recommended for heavier use.
Method of Cleaning: Apply a small amount of cleaner (Windex or similar non-abrasive, non-corrosive product) or Isopropyl alcohol on a micro-fiber.
- Terminal Display: use a micro-fiber cloth and lightly mist it with cleaner to wipe down the case and display. It is very important to NOT spray the cleaner directly at the terminal nor soak the towel so the cleaner runs into the terminal housing.
- Card Slot: (if applicable), use compressed air or a micro-fiber cloth to run back and forth through the card slot to clear out minor dust and debris. For heavier grime in card slot and it is recommended purchasing cleaner cards.
- Finger Scan Sensor: (if applicable), Dampen a lint-free cloth or cotton swab with alcohol or other. Gently rub the cloth across the sensor surface in a left and right direction. Move slowly down the sensor to cover the entire surface area. Repeat this process 2-3 times. Visually observe that no residual solution remains on the sensor.